1333450-2A-A
2
1333450-2A-A
3
5
4
7
8
1
6
2
3
10
11
13
12
9
HANDLE OPERATION
Lift the handle gently. Turn clockwise for hot water, counter-clockwise for cold water.
Pull the diverter for handshower. Push the diverter back in the normal position for bath spout.
Press the buttons of the handshower to change the water flow.
INSTALLATION
INSTALLATION CHECKOUT
How to Maintain the Handshower
Any debris or mineral build-up may cause
the flow stream distorted or reduce the flow
rate. To remove the debris or mineral
build-up, run water through the handshower,
firmly press or rub your finger back and forth
across the rubber nozzles.
How to Install the Faucet
Shut off water supply. Cut away the
extending part of the base protector(1) in
accordance with the tile surface. Remove
plug(2) from the base. Remove protector(3)
from the faucet.
Slide up escutcheon kit(4). Install the faucet.
NOTE:
Keep the faucet vertical to base, to
avoid damaging the O-rings on the bottom.
Keep the spout pointing to tub. Fix the
faucet to the base with screws(5) and
washers(6) through flange(7). Tighten the
screws with hex wrench(8).
Slide down the escutcheon kit, make sure it
is against the finished floor.
Ensure that all coupling nuts are tight.
Ensure that the handle is in the off position.
Turn on the main water supply, and
check for leaks. Repair as needed.
Remove the aerator(15) by key(14).
Remove the handshower(10). Turn on
faucet handle. Run hot and cold water
through spout for about one minute to
remove any debris. Remove and clean the
screen washer. Check for leaks at
this time. Remove any debris. Shut off
the faucet. Reinstall the aerator and hand-
shower.
How to Install the Handshower
If needed, install the restrictor(9) into the
inlet of the handshower(10). Connect
hose(11) to diverter kit and handshower with
washers. Tighten all the connections.
Hang the handshower on the bracket(13) of
the faucet.
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
CLEANING INSTRUCTIONS
14
15
10
