Kohler Mira Logic, Manual

Page: 7 / 16

7 1292000-W2-B
5.
Make sure that the slots in the slide
bar are aligned with the lugs in the
support and fit the two slide bar
supports to the ends of the slide
bar. Make sure that each support is
pushed firmly home.
Note! If replacing an existing Mira
Slide Bar proceed to instruction 8.
6. Using the assembled slide bar and
supports as a template, mark the
position of the two fixing holes using
the centre slot.
Warning! Make sure that there are
no buried cables or pipes in the wall
before drilling.
7. Drill the two 7 mm holes for the
fixing screws and insert the wall
plugs supplied. (Alternatively use
proprietary cavity fixings for dry lined,
stud partition, shower cubicle or
laminated panel walls).
8. Fix the bottom slide bar support to the
wall using the screw provided. Make
sure that the screw is fully tightened.
9. Loosely screw the top slide bar
support to the wall. Press firmly down
on the top slide bar support and, while
continuing to apply force, fully tighten
the screw.
10. Fit the end caps to the slide bar
supports.
11. Check the slide bar cannot be
rotated or vertically moved. If there
is movement remove the slide bar
assembly from the wall. Check the
slide bar support lugs are properly
engaged with the slots in the slide bar
and the supports are pushed fully onto
the slide bar ends. Refit the slide bar
assembly.
12. Refer to sections: Handset Installation
to complete the fittings installation.
End Cap
End Cap
Top Slide Bar
Support
Slide Bar
Clamp
Bracket
Assembly
Wall Plug
Fixing Screw
Hose
Retaining
Ring
Slide Bar
Support Lug
Bottom Slide Bar
Support