-4-
Assemble the bolt cap bases, washer,
and nuts on the exposed T-bolts.
H
andtighten the nuts, then tighten
them an additional 1/2-turn.
Overtightening may cause
breakage or chipping of the
vitreous china.
If the T-bolts extend more than 6mm
(1/4") over the top of the nuts, cut off
the excess and file the end. Wipe
away any residue. Install the bolt cap.
CAUTION: Risk of personal
injury or product damage.
T
T
6mm
Fig.#6
6
T-Bolt
T
Bolt Cap*
Nut
Washer
Bolt Cap Base*
TO INSTALL NEW TANK
Make sure the three tank bolts extend
completely through the holes in the
gasket. Set the tank onto the bowl,
using the tank bolts as a guide. Center
the gasket on the inlet of the bowl.
Assemble the washer and brass nuts
onto the bolts.
Alternately tighten the three brass nuts
so the top of the tank and the top of
the bowl are both level. Be sure the
brass nuts are tight enough to achieve
a wate tight seal.
Over tightening may cause
breakage or chipping of the
vitreous china.
CAUTION: Risk of personal
injury or product damage.
Fig.#7
7
Brass Nut
Washer
Gasket*
*
Tank Bolt
* Shape of the actual gasket may not be the
same as shown, but installation method
remains the same.
*
Supply Shank*
Supply Shut-Off Valve
Fig.#8
8
*
(
)
(
)
TO CONNECT WATER
SUPPLY
* Flexible hose (not provided) are
recommended to connect the supply
line to the fill valve. If you use a rigid
connection(not provided), take care
not to apply side forces to the bottom
of the fill valve. Be sure the rigid
connection must be fit with supply line
completely to prevent damage shank
by forced connection.
If you temporarily plugged the closet
flange with a rag, remove the rag at
this time and ensure that the drain pipe
is clear and free of debris.
Carefully align and lower the
over
the closet flange and T-bolts. Apply full
body weight to the
rim to set the
seal.
Do not lift or rock the
after placement - a new
toilet gasket must be installed if
you break the watertight seal.
bowl
bowl
bowl
CAUTION: Risk of external
leakage.
1033003-T01-N
