5. Installing Lever Handles
Close the valves (hot = clockwise, cold = counterclockwise).
Position a gasket and escutcheon over each valve body.
Fit a spline adapter onto each valve stem.
Wet each O-ring with water.
Install a snap ring and O-ring in the grooves in each stem
adapter.
Position the stem adapters with the hex holes in-line with each
other.
Secure each stem adapter with a provided screw.
NOTE:
To adjust the handle alignment, rotate the spline adapter.
Fit a sleeve and bonnet over each stem adapter.
Thread a bonnet to each valve body until they are tight against
the escutcheon.
Install a center cap to each bonnet.
Fit a long sleeve to each handle arm, and secure it with the end
cap.
Insert a handle arm through each center cap and bonnet.
Install a short sleeve and washer onto each handle arm and
secure them with the end caps.
Screw
Stem
Adapter
Stem
Adapter
Snap Ring
Valve Body
Valve Stem
Gasket
Escutcheon
Escutcheon
Spline
Adapter
O-Ring
Bonnet
Sleeve
Handle
Arm
Center
Cap
Center
Cap
Short
Sleeve
Washer
Hex
Hole
Bonnet
Bonnet
End
Cap
Long
Sleeve
Kohler Co.
7
106386-2-AB
