1. Install the Spout
CAUTION: Risk of personal injury.
Do not lean over the
pipe plug when turning or removing the plug. The lines may
be pressurized.
NOTICE:
Keep the supply tube clean above the finished deck. This
will prevent damage to the O-ring seal (not shown) in the base of
the spout.
Remove the plaster guard (not shown) from the supply tube.
Wrap a rag around the pipe plug. This will prevent water from
spraying as the pipe plug is being removed.
Remove the pipe plug from the supply tube.
Slide the escutcheon up the spout.
Using a 1/8
″
hex wrench, back the setscrews off at the base of the
spout just enough to allow clearance for the supply tube.
Position the spout on the supply tube, then carefully press down
until the spout contacts the finished deck.
Align the spout as desired, then tighten the setscrews at the base.
Slide the escutcheon down the spout until it is flush with the
finished deck.
Spout
Escutcheon
Base
Pipe Plug
Setscrew
Supply Tube
Finished Deck
Kohler Co.
3
1082513-2-A
Summary of Contents for K-8360
Page 11: ...1082513 2 A ...
