1. Prepare the Site
NOTE:
The wall may be higher than 21-1/2
″
(54.6 cm), but the hole
for the mounting bracket must be 20-1/2
″
(52.1 cm) from the floor.
Construct a 2 x 4 surround around the overflowing bath. For
other bathing fixtures, reference the dimensions for your chosen
installation.
Depending on the design of the finished wall, the 2 x 4 may be
cut down to fit flush with the rough wall exterior and match the
overflowing bath outer rim height.
Locate the position along the wall in which the spout will be
mounted and mark the floor and the base 2 x 4.
From the base 2 x 4 mark, measure 3-1/4
″
(8.3 cm) from the
outside surface for the rough wall on the floor.
Cut a 7/8
″
(2.2 cm) hole for the stem mounting assembly.
Measure 20-1/2
″
(52.1 cm) from the floor mark to the upper
framing and mark.
Drill a 1-1/4
″
(3.2 cm) wide x 2-1/4
″
(5.7 cm) deep hole using the
mark as the center point.
21-1/2"
(54.6 cm)
20-1/2"
(52.1 cm)
3-1/4"
(8.3 cm)
7/8" (2.2 cm)
D. Hole
1-1/4" (3.2 cm)
D. Hole
1006092-2-B
4
Kohler Co.
