Kohler Co.
5
1
1323363-T01-E
If you want to check the toilet, first of all, you should:
Unplug toilet power cord.
Turn off the water supply valve if necessary.
10. Auto cover fails
to close/open.
11. Night light does
not work
12. UV sterilization
function does not
work
13. Remote is unable
to display
14. Remote control
fails to connect
to toilet.
15. The seat is not
warm.
A. User is not seated enters or lefts the
sensing area
B. Remote controller "automatic cover-
turning" function is deactivated
C. The toilet is in the process of flushing
A. The night function is turned off
B. The indoor light is too bright
A. User sits on the toilet.
B. The seat is covered by foreign matters or
the seat is wet
A. Battery exhausted.
B. Battery polarities are mounted reversely
C. The remote controller is not woken up
A. Lower battery
B. The remote control is too far from the
toilet
C. The toilet is not yet powered on
D. The toilet is on standby mode
E. The toilet is not connected to the remote
control
A. Remote seat temp set too low.
B. Toilet is on standby mode.
A. Please sit or leave the sensing area
B. Review “Guide on remote controller setting".
C. Wait until the flushing process is completed
A. Please close the cover and reactivate the UV
sterilization again when unseated.
B. Remove the foreign matters or dry the seat
A. Replace with new batteries
B. Reinstall properly
C. Touch remote controller screen of
Approach to the toilet or seated.
Press Wake up key on the remote control
A. Review "Usage and replacement of battery for remote
control" chapter and replace battery accordingly.
B. Review "Communication between remote controller
and the toilet", and approach to the toilet
C. Power on the toilet.
E. Review “Communication between remote and toilet”
and connect toilet and remote accordingly.
D. Press “ ” button on auxiliary keyboard.
A. Set seat temp to proper dial.
B. Press “ ” button on auxiliary keyboard.
A. Refer to night light function in “Guide on usage of
remote controller”.
(Not applicable
in Hong Kong
market)
Summary of Contents for K-77797T-0
