When the cover assembly is lifted up, the drain stopper
should rise approximately 3/8 (10mm) above the
stainer. If sufficient clearance cannot be obtained,
remove the lift rod assembly. Loosen the screw, and
slide the adjusting block up on the adjusting rail to
increase the clearance, or down to decrease the
clearance. Tighten the screw, and insert the lift rod
assembly back into the overflow ell.
"
You may need to
repeat this step several times.
3/8
(10
)
Lift Rod Assembly
Screw
Adjusting Block
Adjusting Rail
Fig.#10
10
Spring
NOTE:
When you remove the stopper for cleaning,
please press the cover assembly to make sure
the spring is in its high position, then insert
stopper into the drain ell.
-5-
1072366-T01-E
