8. Install the Towel Bar
NOTE:
Installation of the towel bar is easiest with two people.
Insert one end of the towel bar into a support; the flat side of the towel bar should be toward the
setscrew.
Slide a washer onto one of the screws with the flat side of the washer facing the head of the screw.
Insert the screw through the mounting hole in the glass.
Slide a second washer onto the screw with the flat side facing away from the glass.
While one person holds the other end of the towel bar, position a support over the screw.
Loosely thread the screw into the support.
IMPORTANT!
Do not overtighten the screws. The glass may break.
Fully tighten both screws by inserting a 5/64
″
hex wrench into the hole in the screw head. Do not
overtighten.
Repeat for the second support.
Make sure the collars on the washers fit into the holes in the glass.
Washers
1/4" x 20 Screw
Support
5/64" Hex
Wrench
Position flat
side down.
Towel Bar
Setscrew
Kohler Co.
13
1054858-2-A
Summary of Contents for K-702101
Page 46: ...1054858 2 A ...
Page 47: ...1054858 2 A ...