Kohler K-4918, Homeowner'S Manual

Page: 2 / 24

Care and Cleaning
To keep this KOHLER urinal looking and performing its best, it is
important to follow these care and cleaning procedures.
Use the KOHLER products listed below for optimum care and cleaning
results. Purchase these products from a KOHLER distributor or call
1-800-4KOHLER for ordering information.
128 oz. (3.8 L) sealing liquid 1048656
32 oz. (946 ml) cleaner 1174866
Urinal ball 1173387
Daily Cleaning
Spray the KOHLER cleaner over the outer surfaces of the urinal.
Allow some cleaner to run down the drain.
Allow the cleaner to stand for approximately one minute.
Wipe the outer surfaces with a clean, non-abrasive cloth.
If necessary, repeat this procedure for heavier soils still present on
the urinal.
To minimize odor and avoid sediment build-up in the trapway, it is
important to flush out your waterless urinal every two weeks. Please
follow the
″
Required Two-Week Flush-out Cleaning
″
procedure below.
Required Two-Week Flush-Out Cleaning
IMPORTANT! Do not set the urinal ball directly into the drain or
force it through the strainer, as this may cause blockage.
IMPORTANT! Always keep the strainer in place over the urinal
drain to prevent debris from entering the drain.
IMPORTANT! Do not use cleaners containing anti-bacterial agents,
or any other urinal puck or mat, as these may reduce the
effectiveness of the urinal ball.
IMPORTANT! Failure to perform flush-out cleaning may eventually
result in a clogged urinal. If the urinal becomes clogged, use a
plunger, urinal auger, or non-KOHLER brand strong acid cleaner. If
you use a non-KOHLER brand strong acid cleaner, thoroughly rinse
the urinal with water after application to minimize acid corrosion on
the seal gasket and downstream piping.
Repeat the daily cleaning procedure.
Remove the used urinal ball and discard.
1048744-5-D 2 Kohler Co.