Tools and Materials
Before You Begin
WARNING: Risk of product damage.
When using this valve
in a fiberglass or acrylic installation, use the thin wall
installation kit (88526).
CAUTION: Risk of product damage.
This valve contains
plastic and rubber components. Do not apply excessive heat
to the valve body when soldering.
CAUTION: Risk of product damage.
Do not apply flux or
acids directly to the valve, as damage may result.
CAUTION: Risk of product damage.
Do not apply
petroleum-based lubricants to the valve components, as
damage may result.
IMPORTANT!
The installer is responsible for installing the valve
and adjusting the maximum water temperature of this valve
according to instructions.
Observe all local plumbing and building codes.
This valve requires a minimum operating pressure of 15 psi (103.4
kPa).
The valve shuts off by water pressure. Do not force the handle in
any direction. To turn the valve off, gently turn it to the
″
Off
″
position.
Flush all piping thoroughly after installing the valve body.
Pipe
Wrench
Adjustable
Wrench
Strap
Wrench
Hacksaw or Tubing Cutter
Propane
Torch
Solder
Hex
Wrench
Thread
Sealant
Plumbers
Putty
Assorted
Screwdrivers
Thermometer
Kohler Co.
3
1150733-2-A
