Install the Lavatory (cont.)
Apply a thin continuous bead of sealant around the flat outside
edge of the bottom surface of the lavatory. Refer to the
countertop/vanity manufacturer’s instructions for the
recommended type of sealant.
Carefully position the lavatory in the countertop cutout so the
″
Kohler
″
logo is to the back.
Thread a washer and nut onto each of the threaded studs from
underneath the countertop.
Hand-tighten the nuts, then turn the nuts another 1/2 turn with
an adjustable wrench.
Wipe away any excess sealant with a clean cloth. Fill any voids as
needed.
Allow the sealant to cure for at least 30 minutes before
proceeding.
3. Installation Checkout
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.
1061942-2-B
8
Kohler Co.
Summary of Contents for K-2834
Page 23: ...1061942 2 B ...
