2. Prepare the Site - Freestanding
Mark the location of the water supply lines from the bath drain.
Use the template provided with the riser tubes to assist you.
Verify the distance between the centerline of the marked holes is
5-29/32” (15 cm) and the distance between the centerline of each
marked hole to the centerline of the drain outlet is 22” (55.9 cm).
Drill the marked holes using a 1-5/8” spade drill bit or hole saw.
Insert the riser support through the drilled holes.
Secure the riser support to the subfloor with eight wood screws
(provided).
NOTE:
To protect the riser support from debris when installing the
finished floor, position the supplied thread protectors in the holes of
the riser support.
Install the 1/2
″
water supply tubing.
Install the finished floor material.
Measure and mark 20-11/16
″
(52.5 cm) up from the surface of the
finished floor onto the water supply tubes. Cut the water supplies
tubes to this height.
IMPORTANT!
The dimensions reference a nominal height of
22-1/4
″
(56.5 cm) from the finished floor to the center of the
predrilled pilot hole in the freestanding bath (see
″
Construct the Tee
Subfloor
Riser
Support
Drain
Outlet
Wood Screw
5-29/32"
(15 cm)
22"
(55.9 cm)
Finished
Floor
21-9/16"
(54.8 cm)
20-11/16"
(52.5 cm)
Water Supply
Tubing
Male Copper
Connections
1054455-2-E
6
Kohler Co.
Summary of Contents for K-18486
Page 54: ...1054455 2 E ...
Page 55: ...1054455 2 E ...
