Product Information
Applicable product:
Integral apron, left drain
K-1114P-GLA
Integral apron, right drain
K-1114P-GRA
Fixture*:
Bathing well
Basin area
bottom
55
″
(139.7 cm) x 23-1/4
″
(59.1 cm)
Basin area top
64
″
(162.6 cm) x 32
″
(81.3 cm)
Weight
149 lbs (68 kg)
To overflow
Water depth
15
″
(38.1 cm)
Capacity
78.5 gal (297 L)
* Approximate measurements for comparison only.
Blower motor:
Heater
V
Hz
A
300 W
120
60
5
Minimum access panel pump/control:
20
″
(50.8 cm) W x 15
″
(38.1 cm) H
required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
120 V, 5 A, 60 Hz
Blower motor is supplied with a 24
″
(61 cm) grounding-type
plug-in cord.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
39 lbs/square foot (190 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
The hot water supply should be 70% of the capacity of the bath or
greater. Installations will vary.
This fixture conforms to CSA B45 and ANSI Standard Z124.1.2. All
dimensions are nominal.
Recommended faucet area
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
2-7/8" (7.3 cm)
3" (7.6 cm)
3-1/2"
(8.9 cm)
1-1/4"
(3.2 cm)
1-1/4"
(3.2 cm)
Tile Flange
Detail
72" (182.9 cm)
42" (106.7 cm)
1-1/2" OD
1" (2.5 cm) from
the Floor to the
Bottom of the Drain
21"
(53.3 cm)
1-1/4" (3.2 cm)
3-3/4"
(9.5 cm)
21"
(53.3 cm)
11-1/16"
(28.1 cm)
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
1076057-1-B
2
Kohler Co.
