Product Information
Applicable product:
Drop-in, 3-side integral flange, left drain
K-1112P-GLF
Drop-in, 3-side integral flange, right drain
K-1112P-GRF
Fixture*:
Bathing well
Basin area
bottom
43
″
(109.2 cm) x 20-1/2
″
(52.1 cm)
Basin area top
53-1/2
″
(135.9 cm) x 32-1/8
″
(81.6 cm)
Weight
110 lbs (50 kg)
To overflow
Water depth
15
″
(38.1 cm)
Capacity
57 gal (215.9 L)
* Approximate measurements for comparison only.
Drop-in cutout dimensions:
58-1/2
″
(148.6 cm) x 40-1/2
″
(102.9 cm)
Blower motor:
Heater
V
Hz
A
300 W
120
60
5
Minimum access panel pump/control:
20
″
(50.8 cm) W x 15
″
(38.1 cm) H
required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
120 V, 5 A, 60 Hz
Blower motor is supplied with a 24
″
(61 cm) grounding-type
plug-in cord.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
36 lbs/square foot (174 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
The hot water supply should be 70% of the capacity of the bath or
greater. Installations will vary.
This fixture conforms to CSA B45 and ANSI Standard Z124.1.2. All
dimensions are nominal.
2-7/8" (7.3 cm)
3" (7.6 cm)
Recommended faucet area
1-1/2" OD
42" (106.7 cm)
21"
(53.3 cm)
10-13/16"
(27.5 cm)
60" (152.4 cm)
3-1/8" (7.9 cm)
21" (53.3 cm)
1-1/4" (3.2 cm)
3-1/2" (8.9 cm)
19-1/2"
(49.5 cm)
1-1/4" (3.2 cm)
1" (2.5 cm) from the
Floor to the Bottom
of the Drain
Drop-In Rim
Detail
Tile Flange
Detail
1-1/4"
(3.2 cm)
1-1/2"
(3.8 cm)
No change in measurements if connected
with drain illustrated. (K-11677 or K-11677M)
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
1076050-1-C
2
Kohler Co.
