Floor standing models
Wall Hung models
Size
Floor Mount
Number of screws required
600
3
750
4
Wall Mount
900
4
1200
5
5
7
7
9
Screw positions
for 600mm floor
mount vanity shown
Alternate drain
position for floor
standing models
INSTALLATION INSTRUCTIONS
VALENCIA
TM
Vanity
3 Water supply and waste pipe holes
4 Fixing the vanity to the wall
(a) Measure and mark the centres for water
supply and waste pipes on the back of the
cabinet.
(c) Having drilled the required holes fit the cabinet
into position over the pipework.
(a) Fix the cabinet to the wall using screws (min
10g x 75mm) and
*
20mm washers. Screw
through the back rail or wall so that they screw
into the nog/s in the wall behind.
*
Washers must be used to spread the load.
NOTE:
Before fastening the cabinet make sure that
the it is sitting level and square and if installing a
floor mounted model ensure that the selected
location is free of bumps and protrusions.
NOTE:
Screws should be positioned in an evenly
spaced pattern as shown below.
Screw positions
for 600mm wall
mount vanity shown
50
50
50
50
NOTE:
This section is only applicable if you have
purchased alternate trims for your vanity cabinet.
(c) Fix the new trims in place using the screws
that were removed from the original trims.
(b) Unscrew 3-4 screws from underneath each
trim and remove the trims from the cabinet.
NOTE:
Keep the screws for use later on.
(a) After both drawers have been removed (refer to
section 1), unscrew the 2 trim fixing screws from
each angle bracket located behind either side of
each trim.
NOTE:
Keep the screws for use later on.
2 Changing drawer trims (Optional)
Upper trim
Lower trim
Angle
brackets
Angle
brackets
(b) With a suitably sized hole saw drill the holes
for the water supply and waste.
ENGLEFIELD
4
