209-1023 CLC Cabinets
6
Checklist • Care & Maintenance
1. Cleaning
A. The cabinet door and interior are constructed of
mirror and aluminum. Use only a damp cloth to
clean. Spray the cloth, not the mirror when cleaning.
Mirrors are damaged by the use of ammonia or
vinegar based cleaners. Rubbing alcohol can be
used for stubborn stains.
B. Use no abrasive cleansers on any part of the
cabinet.
C. The white frame should be cleaned with a damp
cloth only.
4. Installing the toothbrush covers,
hinges & door bumpers
1. Push the toothbrush covers into place, one up, one
down, one up, one down.
2. These covers can be “wiggled “ free to clean the
bristle area when required.
3. Each door holds 2 brushes, one large, one small
per door x 3 doors: 3 large bent handle type
brushes (Reach¨, Oral B¨, Precision¨, etc) 3
straight handle or childrens brushes
4. Install the clear door bumpers in the round indent
area at the top and bottom of the door.
5. Slip the cup portion of the hinge into the door and
install the #4 x 1/2” as shown in Fig 6 & 7.
End
Door
3 Bevels
Center
Door
2 Bevels
End
Door
3 Bevels
Insert hinge down at
an angle into tabs
over door hinge
opening
Lay door down on protected surface
#4 x 1/2" Screw - HAND TIGHTEN ONLY!
Toothbrush
covers
4 per door
Door
bumpers
#4 x 1/2"
Screw
Tri-view
Hinge
SS290
not the CLSK
mirror.
SS293
SS340
BELOW FOR 3 DOOR CABINET ONLY*
(See page 3 for One & Two Door instructions.)
B. This hinge screw attaches the door to
the cabinet and allows up and down
adjustment.
A
A
B
B
FIG. 9
A. These screws in hinge mounting block allow
the door or one corner to move left or right.
