ENGLEFIELD
INSTALLATION INSTRUCTIONS
Page 4
CONSTRUCTION REQUIREMENTS - TIMBER FRAME
1) For showers, identify the type of installation required and construct timber frame in accordance with
below. Englefield recommends installing double studs to fix the wall retainers to.
For the framing of bath tubs and
screens, please refer to the installation guide supplied with the product.
3) Check the fit of the wall liner
(and shelves if applicable)
into the wallboard as shown
in
figure 4
below.
Fig. 3: Recommended
Fig. 4: Check the fit of the wall (and
shelves) prior to applying adhesive
Timber Frame
for Shower Enclosure Installation
C
D
WALL BOARD
884
1164
900 X 1200 X 900
750 X 900 X 750
739
864
984
964
1000 X 1000 X 1000
884
864
900 X 900 X 900
900 X 750 X 900
885
747
D
+2
-0
C
+2
-0
B
+2
-0
A
+2
-0
A
B
WALL BOARD
984
984
1000 X 1000
884
884
900 X 900
900 X 750
734
884
884
1184
1200 X 900
Fig.2: Corner (2 sided) Wall
Fig.1: Alcove (3 sided) Wall
Double studs
for shower
wall retainers
Double studs
for shower
wall retainers
Double studs
*Note: Dimensions
are to the finished
surface of wallboard.
*Note: See page 5 for framing & wall board
preparation for Side Recessed wall liners.
for shower
wall retainers
Double studs
for shower
wall retainers
150mm
The wall board surface must be flat & plumb.
The corner must be square.
Do not plaster, paint or seal the wall board.
Consult the tray/bath installation instructions for
any additional wallboard preparation, eg: notching.
!
IMPORTANT
A typical shower enclosure timber frame is shown in
2) Fix wall board to the studs.
DURACRYL WALL
