background image

   

                                                                          

1266877-2A-B          

                                                                                                                                          2  

  

   

                                                                          

1266877-2A-B           

                                                                                                                                         3

  

INSTALLATION

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft 

cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely 

affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings. 

How to Install the Bracket

Determine a suitable location on the 

finished wall to install the bracket, make 

sure it should avoid buried cables and 

pipes in the wall.

Mark bracket base mounting hole 

locations on the wall according to the 

dimension. Drill two holes in the finished 

wall, the holes should match the 

anchors(1) and be vertically. Install the 

anchors. Tighten screws(3) to fix bracket 

base(2) on the finished wall. 

NOTE:

 The 

bracket base direction as shown. 

Loosen the screw(6) in the bottom of the 

bracket(4) with the hex wrench(5), make 

the bracket can be installed. Apply a ring 

of plumber putty or other sealants around 

the underside of the bracket. Put the 

bracket onto the bracket base and lock 

them by screw and hex wrench. 

Remove any excess putty.

How to Install the Handshower 

and Hose

Flush both water supply

 for about one 

minute before the handshower(7) is 

installed.

Put the screen washer(8) into the shower 

hose(9) connector. Connect the       

handshower to shower hose. 

NOTE: 

Don’t over tighten.

Install check valve(10) and into the 

handshower inlet if needed. 

Hang the handshower on the shower 

bracket. Connect another end of shower 

hose to the water supply.

How to Operate the Handshower

Press the buttons of the handshower to 

change the water flow. 

How to Maintain the Handshower

Any debris or mineral build-up may cause the flow stream to become 

distorted or reduce the flow rate. To remove the debris or mineral 

build-up, run water through the handshower, firmly press or rub your 

finger back and forth across the rubber nozzles.

Remove and clean the screen washer.

Champagne

Katalyst

Intense Massage

1

2

3

4

6

5

7

10

8

9

Reviews: