■
Settings
CAUTION
1. Incorrect wiring to the sensor head or power/switch cables creates the risk of damage to both the controller and sensor head. Confirm
that wiring is correct before turning on power.
2. Record write conditions that were configured by writing them to flash memory. Note that flash memory has a limited life, and the
number of guaranteed writes is 10,000.
■
Preparation for settings
•
Connect the sensor head and power/switching cable to the controller. Refer to "Attaching and detaching of the sensor head and power
supply/switching cables" on page
848.
■
Configuring settings
First specify the built-in cylinder type (SET2) and then configure other settings as shown below.
You can change settings using the procedure below.
General flow
Description
Initial value
Sets the output range of each
channel.
HI: 60 LO:40
Selects the model of mounted
cylinder.
10
Selects the output mode of
each channel.
CO4
Can be used to invert the
switch output of each channel.
S-0
Changes the sensor head
LED indicator.
HI: 60 LO:40
Configures the scaling setting. OFS: 0 FS: 100
Configures the display panel
setting.
bL-1
Configures the LCD display
cycle.
dT-1
Adjusts the switch output
response time of each channel.
Sd-1
Performs initialization 1.
Performs initialization 2
(display, output check).
Adjusts the maximum output
voltage of analog output.
Note 1: Be sure to specify the model of cylinder for mounting.
Failure to do so creates the risk of erratic operations.
2: Since initialization (SET A, SET B) returns settings to their
initial defaults, all data settings to date are lost.
Detection
mode
→
Button operation
Press
→
LCD
→
Button operation
Release
→
LCD
Press
→
Doing nothing returns to detection mode.
LCD ON/OFF
When a value
is displayed,
enters the
detection
mode.
LCD
backlight
becomes
brighter.
increases
value.
decreases
value.
Changes in
accordance
with setting
details.
Note2
Note1
2
駆動機器図面
エアシリンダ
三校
855
旧版
12
03̲2016
Summary of Contents for ZL1 Series
Page 14: ...858 03 2016 ...
