Kogan KAWLM70CNRA, User Manual

Page: 6 / 12

Step 1:
Concrete and masonry walls
Use a spirit level to double check the correct angle of the mount and mark the intended hole
positions with a pencil. Drill holes in the desired locations (60mm deep, 10mm wide).
Insert the screw anchors (W-B) into each pre-drilled hole. With the wall mount held in place,
insert the washers and screws (W-C, W-A), tightening with a socket wrench.
For all wall types:
Ensure washers and screws are aligned in the
centre of opening. Do not install with washers and
screws off to either side.
A minimum of two people are recommended for this installation.
Failure to use safety gear and safe working methods may result in
property damage, serious injury, or death.