Kogan KAMOP151STMA, User Manual

Page: 19 / 28

Steam mopping
• Use a steady back-and-forth motion over the floor, pushing the mop away and
pulling it back towards you. Work your way back over the floor, to avoid walking over
the freshly mopped area.
•
While the microfibre pad will absorb most moisture during mopping, depending on
the floor surface and steam intensity setting some residual moisture may be left
behind. In this case, it is recommended to allow time for the floor to air-dry. A fan
may be directed towards an area to facilitate drying.
• Due to the large size of the mop head, it may have difficulty completely cleaning
certain types of floors (such as ceramic tile) that include crevices of grouting. To
more thoroughly clean floor grout, it is recommended to use the device with the
utility nozzle and grout brush attached for steam cleaning use.
Steam cleaning
• Direct the jet nozzle towards the surface you wish to steam. Use a slight back-and-
forth motion over the area to enhance the cleaning process. To sanitise surfaces,
set steam adjustment dial to a high setting and hold so the jet nozzle is
approximately 1-2 cm from the surface for at least 5 seconds. This is the most
effective method for killing germs and bacteria with the device.
• When using window tool, start by thoroughly steaming entire window or mirror
before turning steam off. Next, press the window tool to top of the surface and pull
slowly downward. Move slowly from one side of the surface to the other in this
fashion until the entire surface is clean.
•
Wipe steamed areas with a clean cloth to remove loosened dirt and grime. Wiping
the area while it is still wet is recommended, but use caution when wiping surfaces
that may still be hot (such as metal).
Notes:
•
It is recommended to vacuum floors before mopping in order to remove dust and
dirt particles.
• Setting the steam adjustment dial to a low setting will help to minimise moisture
left on the floor.
•
To avoid warping or damage caused by heat and moisture, the steamer device
should only be used on properly sealed floor surfaces.