Operation
Before first use:
If using the appliance for the first time, please clean the water tank before use. Always unplug from the
power socket and allow to cool down before cleaning. Wipe the surface of the tank with a damp cloth and
polish with a soft dry cloth. Fill with clean water, plug in and let the water flow until tank is empty: repeat
several times, then refill with clean water to be ready for operation.
Tips:
First use of the appliance: Please run the appliance for about 10 seconds by setting the
Temperature and Volume to 000 and then boil by setting Temperature to 100°C and volume to 000
about one minute
until it reaches boiling point.
The appliance is ready for use - set the Temperature and Volume to desired settings.
1. Fill in Water
Open the lid, fill the water tank with the desired amount of water and then close the lid.
Note:
The water level must be less than Max level
and over Min level
. You can fill the desired water as
per either method illustrated below (A or B).
2. Water Dispensing
Make sure the plug is connected to the wall outlet and fill the tank with the desired amount of water. Place
your cup on the removable water tray, ensuring it aligns with the spout. Press and hold the Lock button for
about 3-5 seconds: the Temp and Volume indicators will light up. Press the Temp button to select desired
temperature and press the Volume button to set correct water volume. Press the
Start/Cancel
button to
begin operation. After approximately 5-10 seconds, the water will flow out continuously from water spout.
Press the
Start/Cancel
button to stop the appliance immediately. Repeat if more hot water is required.
Notes:
•
Do not touch boiling water and steam as they may cause injury.
•
If the appliance stops working and beeps while showing E7 on the panel, this indicates low
water level. Add cool water to the water tank immediately.
5
