Preparation for performance
1. Installation of batteries
a. This unit uses 6 pieces of D size batteries. Open the battery compartment cover
on the underside of the keyboard.
b. Insert batteries according to the schematic describing the positive and negative
poles.
c. Replace the cover.
2. External DC power
a. Insert the female tip of the DC adapter into the DC socket on the rear of the unit.
3. Microphone/external speakers
a. Insert the plug of the microphone into the microphone jack at the rear of the unit.
b. Insert the plug of the external speakers into the speaker jack at the rear of the
unit.
Basic method of performance
Set the power switch to the “On” position to start performing. Power saving mode will turn on if
left idle for more than 3 minutes. To wake, press any key.
The Volume buttons provide 8 volume levels.
Demonstration songs and percussions
Pressing the “Demo” button will play each demonstration song in order, one-by-one.
Pressing the “Demo” button again will skip to the next song.
Tempo can be altered using the “Tempo Up/Down” buttons. Pressing the “Stop” button or any
other function button will quit the demonstration function.
Pressing the “Percussion” button will provide various kinds of percussion sounds to be played
on the keys.
Selection of Timbres
When you turn on the keyboard, the default timbre is Piano. The other timbres are as follows:
Pressing “Timbre select A” button will allow you to choose from timbres 1 through 8. Press the
“B” button will allow you to select from timbres 9 to 16.
Press the shift button “Percussion/timbre” and the percussion function will be changed to timbre
1, and you can choose the relative timbre on the timbre keys from 1 to 8. Pressing “Percussion/
timbre” button again to select from 9 to 16.
