Kogan CERTA CTPTPHD58A, User Manual

Page: 15 / 24

To stop the auger bit from rotating, briefly squeeze then release the throttle lever.
Operating the auger
This product requires the use of two hands to ensure safe operation. Before boring any
holes, you must check that the ground to be drilled has no hidden wires, cables, pipes, fuel
lines, drains or other such hazards, that the auger bit may come into contact with. Inspect
the work area before starting. Remove any objects or debris that could be thrown, jammed,
or become entangled in the auger bit. Adopt a stable stance, always keeping the auger in
front of your body. Grip the handles with both hands ensuring you can safely operate the
control levers. Allow the auger bit to reach full speed before commencing the boring
operation.
It is required that the operator always has a firm grip on both handles with both hands
during operation to compensate for a sudden torque reaction. Turn off the auger and
remove it from the hole. Then remove the spark plug cap from the spark plug. Remove any
jammed debris from the auger bit and examine for any damage before commencing work.
Stopping the Auger
•
Push the STOP/RUN switch to the STOP position.
WARNING:
If the auger bit hits a stone or hard ground etc., the rotation
may stop immediately and give a hard torque reaction.