21
English
5
Remove the blind cap on the top of the
freezer (use a plastic card or spatula to help
loosen the cap) and insert it into the holes
on the right side.
6
Pull off the front panel and place the cable
as shown.
7
Make sure the LED light bar is seated in the
guides and attach the front panel back to
the front.
8
Loosen the two caps on the top of the door.
9
Insert the end of the cable into the hole and
close it with the blind cap.
10
Pull the other cable out and close the hole
with the cap having the cable gland.
11
Loosen the angled plate on the bottom of
the door and screw it on the other side. Do
not turn the metal plate and note that the
small holes must be placed on the plastic
pins while the screw hole and the tapped
hole must be aligned.
12
Loosen the three screws on the lower
hinge plate and remove it. If necessary tilt
the refrigerator to get better access to the
bottom side.
13
Unscrew the hinge pin and screw it back on
the other side.
14
Place the hinge plate on the left side into
position.
15
Tighten the hinge plate securely.
16
Place the door on the lower hinge pin.
17
Keep the door in position. Take the
additional hinge provided and insert the
hinge pin into the corresponding hole in the
door. Hold the hinge plate in position and
screw it.
18
Connect the plug and the socket. Clip the
supplied cap onto the hinge, make sure not
to damage the cable.
19
Pull the two caps off the rails of the door
handle.
20
Remove both cross-head screws.
21
Rotate the handle and place it into position
after removing the blind caps on the other
side of the door.
22
Screw the handle.
23
Place the two caps on the rails of the door
handle. Insert the blind caps into the holes
that have now been visible on the other
side.
Caution
After you have placed the freezer upright
on its feet, wait for 24 hours before you
connect it to the mains to permit the cooling
system to regain full capacity.
KFZ45211-A2-NF_190925_V11_HR.indb 21
25/9/19 3:23 pm
