Koden MDC-5004, Installation Manual

Page: 51 / 156

MDC-5000 Series Chapter 3 Installation method
0092653004-00 3-33
3.4.4 Cable connection for NMEA input/output signals
Figure 3.14 Cable connection for NMEA input/output signals
J3
Navigation devices
THD
GPS Compass
Gyro converter
Log converter
Others
CW-373/374/376
Pin
No. CW-376
Wire color
Signal
name
1 Blue+shirld GND
2 White OUT-A
3 Red OUT-B
4 Orange IN-A
5 Black IN-B
6 Green J3: +12V
J5: +12V
J6: NC
Wiring of J3, J5, J6 port
THD:
Transmitting
Heading
Device
An initial value of the Baud rate of the port is as follows.
J3: 38400bps The Baud rate can switch 4800bps or 38400bps in the radar menu.
J5: 4800 bps [MAINTENANCE] => [I/O] => [BAUDRATE]
J6: 4800 bps
The sentence input to these ports is shown below.
Position information: GLL, GGA, GNS, RMC, RMA
Heading information: THS, HDT, HDG, HDM, VTG, RMC, RMA
Speed information: VBW, VTG, VHW
Set and drift: VDR
Waypoint information: RMB, BWC, RTE, WPL
Routes: RTE, WPL
Cross-track: RMB, XTE
Datum: DTM
Depth: DBT, DPT
Temperature: MTW
Date: ZDA, RMC, GGA
LOP: GLC
Wind: MWD
ROT: ROT
These sentences can select the port of each sentence input in the radar menu.
As for the J6 port, the transmission cycle is set at 0 seconds and not output by default.
The J5 port is output TTM sentence in a cycle for 1 second by default.
The J3 port is output at the following cycles by default.
EVE=1.0s, HBT=5.0s, OSD=1.0s, RSD=1.0s, TLB=5.0s
J5
J6
1
2
3
4
5
6
Cable connector pin assignment