Koden KDS-5000BB, Operation Manual

Page: 32 / 112

- 24 -
INSTALLATION
4
) Mount the shaft cap at the end of TD shaft
Insert the shaft cap into the TD shaft.
Screw it with the cap bolts, M4x25 (4 pcs).
Screw the cap bolts, M4x10 (4 pcs) to prevent slip-out of the shaft cap.
5
) How to tighten the nuts
Lift up the Lock Nut as shown in the drawing. Place the Waterproof Nut on the Flange opening
and tighten it firmly by hand and then make a 180-degree turn with a screwdriver.
Take care not to over a 180-degree. This Lock Nut is to protect loosening the Waterproof Nut.
Screw the Lock Nut tightly with a screwdriver and a hammer.
１８０゜
＜
To be continued
＞
Cap Bolt
M4 x 25
Shaft cap
Ensure the bolt position each.
Cap Bolt
M4 x 10
WATER PROOF NUT
After tightening the Water
Proof Nut by hand, use a
Screw Driver to clamp it
further by 180
°
.
LOCK NUT