LFO TAB
:
Waveform
(0 ~ 23): Selects the waveform you want to use
with your LFO. It’s the same waveform set used into
synthesis.
Mask
(0 ~ 12): This mask distorts and reshape the selected
LFO waveform. It doesn’t overwrite the original waveform.
Phase Offset
(0 ~ 31): Here you can set the point where
the LFO waveform will start to play.
Random Phase
: Use a random number generator to set
the LFO waveform start point when the note is played.
Common Phase
: If checked, the LFO isn’t triggered at each Note On, but it still work at background,
and the voice is just “connected” to the LFO when Note is triggered.
Speed
(0 ~ 127): Sets the LFO speed rate
Delay
(0 ~ 127): Sets the delay between the Note On message, and the start of the LFO.
Attack
(0 ~ 127): Sets the slope of LFO amount when triggered
FILTER TAB
:
D/W Balance
(0 ~ 127): Here you can set the balance
between the dry sound and the filtered sound. It works
in the same way you can find in any serial connected
audio processor. A value of 64 means you’ve got a 50%-
50% mix between dry and filtered sound.
Resonance
(0 ~ 120): This slider allows you to set the
resonance of the filter
Cutoff Env
(5-segment): This envelope allows you to
control cutoff evolution during the time. See Envelope
Edit section to know more about manipulating
envelopes.
