3. If using the 12V camera AC adapter, just connect power jack, and make
sure the camera is positioned no more than 5.5 feet from the AC power
outlet.
4. To get the best performance from the camera, please follow these
guidelines.
For the best performance, mount the camera between 2.5 and 4 meters
above the detected area.
Built-in IR sources (8 LEDs) provide short night vision. For day use,
please turn off the LEDs by sliding the NIGHT VISION SWITCH (on the
right side of camera head) to the OFF position.
To avoid problems with false sound trigger, adjust the sound trigger level
by tuning the TRIGGER LEVEL TUNER (on the right side of camera head).
5. Select the transmission channel on the SLIDE SWITCH (on rear of the
camera head) by sliding switch to position 1,2 or 3. Camera is preset to the
channel 1.
6. The camera (transmitter) installation is now complete.
·
·
·
RIGHT SIDE VIEW OF
THE BABY CAMERA
SLIDE SWITCH
SET TO NIGHT VISION ON
SLIDE SWITCH
SET TO NIGHT VISION OFF
Trigger
RIGHT SIDE VIEW OF
THE BABY CAMERA
TRIGGER TUNER
SET TO TRIGGER LEVEL
1 2 3
1 2 3
1 2 3
REAR VIEW OF
THE BABY CAMERA
SLIDE SWITCH
SET TO CHANNEL POSITION
1
SLIDE SWITCH
SET TO CHANNEL POSITION
2
SLIDE SWITCH
SET TO CHANNEL POSITION
3
Installing the Palm LCD Monitor (Receiver) ///
1. Plug the palm monitor AC adapter into the 6V DC power jack on rear of
the receiver.
TO PALM MONITOR
POWER JACK
PALM MONITOR
POWER SUPPLY
POWER JACK
A/V OUTPUT
DIP SWITCH
2
Trouble Shooting ///
If you are having trouble operating this product, please consult the guide
below:
1- Check all connectors. Make sure camera(s) and
palm monitor are switched ON.
2- Ensure camera(s) & palm monitor are set to correct
channel(s).
3- Make sure camera is within range of palm monitor.
1- Make sure the palm monitor is switched ON.
2- If using AC adapter, make sure it is plugged in.
3- Make sure all batteries are placed in right direction
and have battery life.
1- Make sure each camera (transmitter) is within the
range, and that no large obstructions are locking
the signal.
2- Try repositioning the camera, palm monitor or
both to improve the reception quality.
3- Reposition other nearby equipment transmitting
on 2.4 GHz frequency.
1- Ensure the volume is turned up sufficiently on the
palm monitor.
2- Make sure the sound is within the microphone
range.
3- If the unit emits a loud wailing sound (feeds back),
try moving the camera away from the palm monitor
or angle the palm monitor differently.
SYMPTOM
REMEDIES
No Camera Picture
Blank Monitor
Interference on
Camera Picture
Audio problems
Specification ///
TV System
PAL or NTSC standard
Integrated Lens
5.6mm, fixed focus
Resolution
360 horizontal TV lines
Signal/Noise Ratio
48dB
Image Sensor
1/3 CMOS
Min. Illumination
0.1 lux
Current Consumption 150mA
Frequency Range
2.41~2.47 GHz
Modulation
FM
Channel Selection
Electronic tuning with PLL
Overall Size
3.75
Camera(Transmitter)
"
"
W * 4.25 H * 2.45 D
95mmW * 107mmH * 62mmD
"
"
5
