HND-T205
HND-T205 K05/0422
page 13
7.8 Operation of Logger
The device supports two different logger functions:
„Func-Stor“:
each time when „store“ (key 6) is pressed a measurement will
be recorded.
„Func-CYCL“:
measurements will automatically be recorded at each interval,
which was set in the logger menu ‚CYCL‘ until the logger will
be stopped or the logger memory is full. The recording is
started by pressing „Store“ 2 seconds.
The logger records 1 measurement result each time
The data set consists of:
-measuring value at time of recording
-time and date of recording
For the read out and evaluation of the data the software HND-Z034 (at least V.
1.7) has to be used. The software also allows easy configuration and starting of
the logger.
When the logger is activated (Func Stor or Func CYCL) the hold function is no
longer available, key 6 is solely used for the operation of the logger functions.
7.8.1
Storing Single Measurements („Func-Stor“)
a) Record Measuring:
If the logger function “Func Stor” was activated (see chapter Device
configuration), up to 99 measuring data sets can be recorded manually.
Press shortly: data set will be recorded (“St.XX” will be shown shortly.
XX is the number of the data set)
If the logger memory is full, the display will show:
b) Viewing Recorded Measurings:
Stored data sets can be either read out via PC Software HND-Z034, or be viewed
in the display directly.
Press for 2 seconds:
The display will show:
Note: “rEAd Logg” only appears, if there are already data stored! If
memory is empty, the configuration menu
will show.
