4/12
September
/ 2006
4.-ASSEMBLY SURE REPLACEMENT ( 4 )
4.1.- Follow steps 2.1,2.2 and 2.3
4.2.-Remove the dust cover ( 4-G ) and two screw ( 4-F )
4.3.-Remove the assembly sure and replace the component damaged and reassemble
5 LINE CORD ASSEMBLY REPLACEMENT ( 32 )
5.1.- Follow the steps indicated on points 2.1,2.2 and 2.3
5..2.- Disconnect the ground ( green ) as well as the lead connected to the micro switch ( 27 )
5.3.-With HEYCO pliers remove the grommet ( 33 ) as well as the washer ( 34 )
5.4.- Remove GROMMET line tube ( 35 ) as well as the motor leads assembly ( 32 )
5.5.- Replace the motor lead by inserting the handle assembly ( 10 ) upwards and previously placing the GROMMET tube
( 33 ) at the same distance as the prior lead
5.6.-place the washer ( 34 ) as well as the grommet ( 33 ) connect and reassemble as initially placed
6 LINE CORD REPLACEMENT ( 40 )
6.1.- Follow steps 2.1,2.2 and 2.3
6.2.- Disconnect ground (Green ) as well as connection micro switch ( 27 )
6.3.- With HEYCO tool, remove HEYCO GROMMET ( 33 ) and replace line cord
NOTE : MAKE SURE LINE CORD IS PROPERLY CONNECTED TO CONNECTION BOX
7 YOKE REPLACEMENT ( 73 )
7.1.- Loosen handle lever ,remove screws ( 42 ) and bolts ( 41 )
7.2.- Pull tube assembly ( 10 ) upwards
7.3.- Remove the truarc ( 75 ) remove the Allen oppressor locks ( 76 ) and remove one side of the yoke axle ( 74 )
7.4.- Replace yoke and reassemble
III.- TROUBLE SHOOTING CHART
1.- MOTOR DOESN’T START
POSSIBLE CAUSE
SOLUTION
CONNECTED
CHECK CONNECTED
LINE CORD DAMAGED
REPLACE
LINE CORD IMPROPERLY CONNECTED
REVISE CONNECTION
LINE CORD DAMAGED
REVISE LINE CORD
MICRO SWITCH DAMAGED
REPLACE MICRO SWITCH
CAPACITOR DAMAGED
REPLACE CAPACITOR
MOTOR LINE CORD DAMAGED
REPLACE MOTOR LINE CORD
MOTOR ASSEMBLY DAMAGED
REPLACE MOTOR ASSEMBLY
PISTON AND SPRING DAMAGED
REPLACE
https://harrissupplyind.com - To Order Parts Call 608-268-8080
