Getting Ready
Note
If a new SD card is used, you are required to format it first. Please refer
to page 24 for details.
Note
With a built-in flash memory, the image(s) can be stored either in it or in
memory card. Only if the memory card is inserted, the images will be
stored in the memory card rather than the built-in flash memory. On the
other hand,the images will be stored in the built-in flash memory only if
a memory card is not inserted.
Removing an SD Card
1. Check if the camera is switched off.
2. Open the Battery / Memory Card Cover.
3. Press down the SD card and the card will jump up.
4. Close the Battery / Memory Card Cover.
Attaching the Wrist Strap
Getting Started
Basic Photography
1. Open the lens cover.
2. Switch on the power.
3. Set the Mode Dial at Shooting Mode ( ) for still image or Movie Clip
Mode ( ) for video recording.
4. The setting of the focus range for still image capture is required as follows
►
Macro ( ) : 0.2m
►
Normal ( ) : 0.8m~infinity
5. Refer to the next section -- Advanced Functionality Settings (page14) to set
up the features you prefer.
6. Hold still and press down the Shutter Button.
7. The LED Indicator starts blinking right after the Shutter Button is released.
8. Once the LED Indicator stops blinking, you are ready to take another shot.
Note
A message of "LENS COVER" blinking on the TFT LCD Monitor as a
warning is to remind you of opening the lens cover first.
Note
A message of "Low Light!" appearing on the TFT LCD Monitor as a
warning is to remind you that the image that you are going to capture is
under a low light environment. To compose a good quality image, it is
strongly recommended to go to the Flash Mode to select Auto Flash or
Fill-in Flash tosupply more light sources.
S
5
1
2
3
4
13
12
