10
7
PLEASE NOTE: The batteries are supplied with a low charge. To prolong the life of the batteries, charge
the batteries fully before first use.
1.
Remove the battery from the power tool by pressing the battery
release button
(7 or 13)
and pulling the battery out of the drill
(See Fig.1).
2.
Insert the battery into the charger provided only. Align raised part on
the battery with the groove in the charger. Using any other charger
than the one provided can cause severe damage and may even
cause the battery to explode.
(See Fig.2).
3.
Connect the charger to the power supply and charge for the time
stated below.
CHARGING TIME: 60mins approx
.
4.
The red pilot light on the charger will remain on and the green pilot
light will flash, indicating that the battery is charging. Once the battery
is charged the red pilot light will turn off and the green pilot light will
turn on.
5.
When the battery is fully charged, unplug the charger from the power
source and remove the battery from the charger by pressing the
battery release button
(7 or 13).
PLEASE NOTE: The battery may feel slightly warm while charging. This is normal and does not indicate a
problem. Do not place charger in an area of extreme heat/cold. Charge the battery at an atmospheric
temperature of between 0 and 45˚C. Not for outdoor use. The battery will not reach its full charge after
the first time of charging. Allow several cycles of drilling followed by re-charging for them to become
fully charged.
KOBE
INDUSTRIAL
POWER TOOLS
OPERATION
CHARGING THE BATTERY:
DANGER! Do not insert the battery into the charge if the battery case is
cracked or damaged in anyway.
WARNING! BEFORE ATTEMPTING TO USE THE POWER TOOLS, MAKE SURE
YOU ARE FAMILIAR WITH ALL OPERATING AND SAFETY INSTRUCTIONS.
KOBE
INDUSTRIAL
POWER TOOLS
OPERATION
DRILLING (COMBI DRILL ONLY):
1.
Ensure that the material to be drilled is secured in a vice or with clamps to keep it from turning as the
drill bit rotates.
2.
Hold the drill firmly and place the drill bit at the point to be drilled.
3.
Depress the trigger
(9)
to start the rotation of the drill.
4.
Move the drill bit into the workpiece, applying only enough pressure to feed the cutting. Do not force or
apply side pressure to elongate a hole.
5.
Once hole is drilled switch the drill into reverse and guide out.
If drilling into metal use a light oil on the drill bit piece. This will help prevent the drill bit overheating and
prolong the life of the drill bit.
Please note: When drilling hard smooth surfaces use a centre punch to mark the desired hole location.
This will prevent the drill from slipping off centre as the hole is drilled. However, the lower speed
setting: 1 allows the starting of holes without punching if desired.
If the drill bit jams in the workpiece or if the drill stalls, stop the drill immediately, remove the drill bit
from the workpiece and determine the reason for jamming before continuing.
WARNING! Be prepared for binding or breakthrough. When these situations
occur, the drill has a tendency to grab and kick in the opposite direction
and could cause loss of control which could results in serious personal
injury.
FIG.1
FIG.2
LED LIGHT (10 OR 16):
Both the Combi Drill and the Impact Driver have LED Lights
(10 or 16)
to illuminate the workpiece.
The lights illuminate when the trigger is depressed and cuts off when the trigger is released.
WARNING! DO NOT STARE AT THE LED LIGHT NOR SHINE IT IN OTHER
PEOPLE’S EYES.
KOBE
INDUSTRIAL
POWER TOOLS
SPARES
1.3AH LI-ION BATTERY
ORDER CODE: KBE-280-0145K
1.3AH LI-ION BATTERY CHARGER
ORDER CODE: KBE-280-0145A