KOBE IS2136SQB, Installation Instructions And Operation Manual

Page: 9 / 66

7
5. Use eight 3/16” x 3/8” screws (provided) to secure
hood to support frame. Make sure to tighten screws
securely. Refer to Figure 5.
CAUTION: MAKE SURE HOOD IS SECURE
BEFORE RELEASING.
Ductwork Installation
6. Use 8” round steel pipe (follow building codes in your
area) to connect the ducting transition on the hood to
the ductwork above. Use duct tape to make all joints
secure and air tight. Refer to Figure 6.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD
MUST BE PROPERLY GROUNDED. MAKE SURE
THIS IS DONE BY SPECIALIZED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL ELECTRICAL CODES. BEFORE
CONNECTING WIRES, SWITCH POWER OFF AT
SERVICE PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
7. Connect the electrical wires.
-
Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect according to color: black to black, white
to white, and green to green as shown on Figure
7.
-
If necessary to hide the electrical wire
connections, push wires back into the wiring box.
Access the wire connections underneath the
hood. Make sure wires do not slip between motor
or any moving parts to prevent any damage.
Figure 5
Figure 6
Figure 7