5
7.
If an elbow is necessary, a minimum of 12” straight run is necessary before the elbow.
Clearance
8. Clearance is the distance between the cooktop and the bottom of the range hood. The
recommended minimum clearance for this model is 26” and the maximum clearance is 30”.
9. It is important to install the hood at the recommended clearance. Installing too low could result in
damage and/or fire hazard while installing too high may result in reduced performance and
efficiently.
Hood Installation
10. Prepare back wall frame with cross framing lumber for
secure installation if necessary. Using references on
TABLE 1 and measurements on page XX to decide the
level of the lumber. Refer to Figure 1.
11. Mark the leveling point of the hood. Position two 4*35
screws on the wall, leaving 1/8” away from the wall as
shown in Figure 2.
12. Align hood-mounting bracket to the two screws on the wall
and hook the hood into place. Tighten screws to secure
hood to the wall. Refer to Figure 3.
Ductwork
13.
Put the two flappers on 6” round exhaust vent adapter.
NOTE: striped side of the flapper is facing out.
14.
Attached the rubber plate to the bottom of 6” round
exhaust vent adapter then attached to the exhaust
opening and use six 4*6 screws to secure it.
15.
Use 6” round steel pipe (not included) to connect the 6”
round exhaust on the hood to the ductwork above. Use
duct tape to make all joints secure and air tight.
Duct Cover Installation
16. Use reference E from TABLE 1 and measurements on
page XX to mark the position of the duct cover-mounting
bracket.
17. Secure the duct cover-mounting bracket to the wall with
two 4*35 screws. Make sure all screws are tightened.
Refer to Figure 4. NOTE: Inner duct cover will cover the
duct cover-mounting bracket.
18. Put the entire duct cover onto the hood. Secure the outer
duct cover with two 4*8 screws to the hood-mounting
bracket. Refer to Figure 5.
19. Slide the inner duct cover until it reaches to the duct cover-
mounting bracket. Secure inner duct cover with two 4*8
screws to the duct cover-mounting bracket. Shown in Figure 6.
Figure 1
Figure 2
Figure 3
