KMD-S04
15
www.grupotemper.com
D. Frequency and Duty Cycle Measurement
(see figure 4)
Warning
To avoid harm to you or damages to the Meter, do not attempt to measure voltages
higher than 60V in DC or 30V rms in AC although readings may be obtained.
The testing resolution may vary from the inputted frequency and waveform, the Meter
resolution is based on the sine wave.
Note
When Hz or Duty Cycle measurement has been completed, disconnect the connection
between the testing leads and the circuit under test.
To measure frequency and duty cycle, connect the Meter as follows:
1. Set the rotary switch to
ACV
or
DCV
range.
2. Press
Hz/DUTY
button select Frequency or Duty Cycle measurement mode.
3. Connect the test leads across with the object being measured.
The measured value shows on the display.
E. Measuring Diodes & Continuity
(see figure 4)
Warning
To avoid damage to the Meter or to the equipment under test, disconnect circuit power
