7
OPERATING INSTRUCTIONS
1. To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, then
slide the battery pack onto the tool, as shown.
b. Make sure that the battery-release buttons
on the battery pack snap into place and the
battery pack is secured to the tool before
beginning operation.
NOTICE:
When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull forward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always turn off the area light and
remove the battery when the area light is not in use or when carrying it at your side.
2. ON/OFF Switch
a. To turn the area light ON, press the ON/OFF
switch (D). The area light will be turned on at
maximum brightness and 360°area.
b. To reduce the brightness, press the ON/OFF
switch again.
c. To turn it OFF, press the ON/OFF switch third
time.
WARNING
• Do not continue to press the ON/OFF switch
after the area light has been automatically
switched off. The battery can be damaged.
SOS mode
a. The area light will switch to SOS mode (blinking rapidly) when long press the ON/OFF
switch.
b. To quit the SOS mode, press either the ON/OFF switch or the area switch. It will back to
the mode before.
1
Battery release buttons
2
D
