5
KOAMTAC, Inc.
|
116 Village Blvd. Suite 305
|
Princeton, NJ 08540
|
phone
609.256.4700
|
fax
609.228.4373
www.koamtac.com
2.3
How to use KDCSLED-UHF1.0W
➢
It is recommended to use KDCSLED-UHF1.0W as below picture to read RFID tag.
➢
For optimal UHF tag read performance and to be sure that human exposure to RF energy does not
exceed the FCC, European Union guidelines, always follow below instructions and precautions:
o
Before using KDCSLED-UHF1.0W reader, user should carefully read this manual to understand
how to use KDCSLED-UHF1.0W reader properly.
o
KDCSLED-UHF1.0W reader should be used by professional person who understand fully how to
operate KDCSLED-UHF1.0W reader.
o
Maintain at least 20cm between KDCSLED-UHF1.0W reader and the body when reading UHF
RFID tag.
o
Keep KDCSLED-UHF1.0W Antenna to face the UHF RFID tag, but not your body when reading
UHF RFID tag.
o
Exit UHF tag read mode and keep Barcode read mode when finished reading UHF tag.
o
Don’t wear
KDCSLED-UHF1.0W reader when not using KDCSLED-UHF1.0W reader.
3.
KDCSLED-UHF1.0W Configuration
3.1 Read Mode (Barcode-reading mode vs. Tag-reading mode)
➢
There are two read modes. One is barcode-reading mode (Barcode can be read by SCAN button) and the
other one is tag-reading mode (UHF Tag can be read by SCAN button).
➢
After reset, KDC470 is set to a barcode-reading mode.
➢
The mode can be changed when you press and hold UP button for 3 seconds.
➢
Or, the application can also change the mode between a barcode-reading mode and a tag-reading mode
using SDK.
➢
When the mode is changed, 3 short beeps means a tag-reading mode. 1 long and 1 short beeps means a
barcode-reading mode.
