OPE-ESYSLR-0286-E
©Knox Company. All Rights Reserved
KNOX ELOCK CORE RETROFIT:
KLS-3200 & KLS-1650 INSTALLATION GUIDE
4
1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 |
T.
800-552-5669 |
F.
623-687-2290 | [email protected] |
KNOXBOX.COM
This concludes the Knox eLock Core Retrofit Instructions.
Installation of the Knox RainGuard
™
:
Mount the Knox RainGuard to the Dust
Cover Bracket. The Knox RainGuard’s
open circle will fit tightly around the
Lock Shell.
14
Use the provided alcohol wipe to clean the
backside of the Dust Cover and the surface
area all around the Lock
(see note below
regarding Dust Cover Magnet).
12
Using the nose of the foam as a guide,
fold upper half of the Knox RainGuard
to align with the Lock Core center. The
nose will fold over and into the Lock
Core for protection.
15
Remove the adhesive backing from the
back side of the Knox RainGuard's upper
half. Pull out and close Dust Cover with
pressure allowing the Knox RainGuard
to firmly attach to the Dust Cover. Lift the
Dust Cover up and press both halves of
the Knox RainGuard for a firm fit.
16
Lastly, remove the adhesive backing
from the Knox "K" reflective label, and
place front and center of the Dust Cover.
17
Use a flat head screwdriver to remove
the Dust Cover Magnet from the Dust
Cover Bracket.
11
Use a sharp instrument to remove the
adhesive backing from the bottom half of
the Knox RainGuard. The bottom half is
the section with the open circle.
13