KNOVA KN M-2500W, Manuals

Page: 17 / 46

OPERATION
16
When setting the bevel and miter angles for compound miters,
remember that the settings are interdependent; changing one
changes the other, as well.
Bevel/Miter Settings
Settings for standard crown molding lying flat on compound miter
saw table
NOTE: The chart below references a compound cut for crown
molding ONLY WHEN THE ANGLE BETWEEN THE WALLS
EQUALS EXACTLY 90°.
KEY
BEVEL
SETTING
MITER
SETTING
TYPE OF CUT
Inside corner-Left side
IL 33.9°
31.6°
Right
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. LEFT side is finished piece.
Inside corner-Right side
IR
33.9°
31.6°
Left
1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. LEFT side is finished piece.
Outside corner-Left side
OL
33.9°
31.6°
Left
1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. RIGHT side is finished piece.
Outside corner-Right side
OR 33.9°
31.6°
Right
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. RIGHT side is finished piece.
Fig. DD
Fig. EE
MAINTENANCE
To avoid injury, never put lubricants on the blade while it is
spinning.
DANGER
To avoid fire or toxic reaction, never use gasoline, naphtha
acetone, lacquer thinner or similar highly volatile solvents to
clean the miter saw.
WARNING
To avoid injury from unexpected starting or electrical shock,
unplug the power cord before working on the saw.
WARNING
For your safety, this saw is double-insulated. To avoid elec-
trical shock, fire or injury, use only parts identical to those
identified in the parts list. Reassemble exactly as the original
assembly to avoid electrical shock.
WARNING
REPLACING CARBON BRUSHES (FIG. FF)
Replace both carbon brushes when either has less than 1/4
in. length of carbon remaining, or if the spring or wire is dam-
aged or burned. To inspect or replace brushes, first unplug
the saw. Then remove the black plastic cap (1) on the side of
the motor (2). Remove the cap cautiously, because it is sprin-
gloaded. Then pull out the brush and replace. Replace for the
other side. To reassemble reverse the procedure. The ears on
the metal end of the assembly go in the same hole the carbon
part fits into. Tighten the cap snugly, but do not overtighten.
NOTE: To reinstall the same brushes, first make sure the
brushes go back in the way they came out. This will avoid a
break-in period that reduces motor performance and increas-
es wear.
Fig. FF
Miter saw table
F
e
n
c
e
Outside Corner
Inside Corner
Compound Cut Crown Moldings