KNOVA KN IW-1010, Manual

Page: 2 / 12

SPECIFICATIONS
GENERAL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING: Read and understand all instuctions.Failure to follow all instructions
listed below may result in electric shock fire and/or serious personal injury.
Work Area
Keep your work area clean and well lit.
Cluttered benches and dark area invite
accidents.
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases, or dust. Power
tools create sparks which may ignite the
dust or ruins.
Keep bystanders, children, and visitors
away while operating a power tools.
Distractions can cause you to lose
control.
Electrical safety
Don’t expose power tools to rain or wet
conditions.Water entering a power tools
will increase the risk of electric shock.
Do not abuse the cord. Never use the
cord to carry the tools or pull the plug
from an outlet. Keep cord away from heat,
oil, sharp edges or moving parts. Replace
damaged cords immediately. Damaged
cords increase the risk of electric shock.
When operating a power tools outside,
use an outdoor extension cord marked
“W A”or “W”. These cords are rated for
outdoor use and reduce the risk of electric
shock.
Personal safety
Stay alert,watch what you are doing and
use common sense when operating a
power tool. Do not use tools while tried or
under the influence of grugs, alcohol, or
medication. A moment of inattention while
operating power amy result in serious
personal injury.
Dress properly. Do not wear loose cloth-
ing or jewelry,. Keep our hair, clothing
and gloves away from moving parts.
Loose clothes, jewelry, or long hair can be
caught in moving parts.
TECHNICAL DATA
Power supply
Power input
No. load speed
KN IW-1010
120V~/60Hz
1,010 W
2,200 rev/min Torque
Square drive
Net weight 450 Nm (332 ft/lb)
1/2” (12.7mm)
3.89 kg
Avoid accidental starting. Be sure switch
is off before plugging in. Carrying tools
with your finger on the switch or plugging
in tools that have the switch or plugging
in tools that have the switch on invites
accidents.
Remove adjusting keys or switches before
turning the tool on. A switch or a key
that is left attached to the tool or rotaing
part may result in personal injury. Please
check the sockets carefully be using.
Use satefy equipment. Always wear eye
protection. Dust mark, non-skin safety
shoes, ahrd hat, or hearing protection
must be used for appropriate conditions.
Tool Use,maintenance and Care
Use clamps or other method to secure
and support the workplace to a stable
platform. Holding the work by hand or
against your body is unstable and may
lead to loss of control.
Do not force tool. Use the correct tool
for your application. The correct tools will
do the job better and safer at the rate for
which it is designed.
Do not use tool if switch does not turn it
on or off. Any tool that connot be
controlled with the switch is dangerous
and must be repaired.
Disconnect the plug from the power
source before making any adjustments,
changing accessories,or storing the tool.
Such preventive safety measures reduce
the risk of starting the tool accidentally.
Store idle tools out of reach of children
and other untrained persons.Tools are
dangerous in the hands of untrained
users.
Maintain tools with care. Keep cutting
tools sharp and clean. Properly
maintained tools with sharp cutting edges
are less likely to bind and are easier to
control.