KNOVA KN GEN-16, User Manual

Page: 5 / 24

4
DESCRIPTION OF SPARE PARTS
(10)
(9)
(8)
(7)
(6)
(5)
(4)
(3)
(2)
(1)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(1) Chock valve
(2) Air cleaner
(3) Starter grip
(4) Oil drain bolt (5) Oil filler cap
(6) Engine switch
(7) AC output
(8) Output indicator (9) Control panel
(10) Circuit breaker
(11) Fuel tank cap
(12) Fuel tank (13) Cover, generator end
(14) Muffler
(15) Cylinder head
(16) Carburetor
(17) Spark plug
Fuel tank
Fuel
tank cap
AC circuit
breaker
AC
output
It is used to hold fuel, gasoline is allowed only.
Screw the fuel injection port in use and do not
open it in equipment operation.
It will break to protect the electric device
when current is too heavy.
AC output socket provides the power supply.,
Please refer to model’s parameter table for
its rated power. load of each socket cannot
exceed its rated current, and total power of
electric device cannot surpass rated power of
the generator Do not start up several electric
devices simultaneously, but switch on another
one after stable operation of one electric device.
Output
indicator
Engine
switch
It is to indicate power supply status.
The indicate will brighten up when
the equipment operation.
It is to start up (applicable to electrical
starting only) and switch off engine.
Turn to the off state in nonuse.
Oil filler
cap
Oil drain
bolt
It is for measurement of engine’s oil level.
Make sure engine’s oil level is between MIN and
MAX in the dipstick of oil filler cap before use.
Oil can be added after removing the oil filler cap.
Unscrew this bolt when replacing the engine
oil. Drain out the old engine oil and dispose of
it properly according to local laws, avoiding
damage to the environment.
Grounding
terminal
It is to make the generator realize safe grounding.
As to the grounding method, refer to the page
5. Make sure unobstructed grounding before use.
Starter
grip
It is to start up the engine.
For the method, refer to the page 5.
Air
cleaner
Fuel
switch
Choke
valve
Muffler
It is to filter air and remove impurities
in the air entering cylinder. As to the
maintenance method, refer to page 8.
It is to control fuel’s entering into the engine
via fuel tank During nonuse of generator,
leave the switch off.
It is to control air flow into the cylinder when
starting up the engine. As to the
operating method, refer to the page 6.
It is to eliminate noise during equipment
operation, and discharge high temperature
exhaust of engine’s combustion. Do not touch
it to avoid scalding.
Sockets can be
following patterns
according
to relevant
regulations in
various areas:
When the
rated current from
one socket output
more than the
socket‘s nominal
rated current, you
should to use
simultaneously
two or more
sockets for
power output.
WARNING