and twist about 1/2" of insulation off wires. The wire runs should be hidden as well as possible (ask your
dealer for tips to conceal wires).
4.
Remove the speaker grills.
5.
Connect the speaker wire to the SR62s speaker carefully observing correct speaker terminal polarity.
6.
Slip the speaker into the opening cut in the wall or ceiling, and with a Phillips screw driver screw all three
mount crews in a counter clockwise direction until the speaker is snugly in place (just snug, don't over
tighten).
7.
Adjust the swivel tweeter
so it aims directly at the center of the listening area
.
8.
Turn the amplifier on, turn the room volume controls up and test the speakers.
9.
Snap the white (paintable) grill into the SR62s speaker bracket.
Installation: New Construction
1.
Run two wires from the amplifier location to the room volume control (optional) then to the intended
speaker location. Loop an extra 1m (3') of wire out from the ceiling or wall. ID tag the wires.
2.
After wall board or sheet rock is installed, make sure the 7-1/4" speaker hole is cut out correctly then
follow steps 4-9 in "Existing Construction" above.
Amplifier or Receiver
The amplifier or receiver should provide more power than will be needed. Always reduce sound levels
immediately if sound distortion is present. Any amplifier, especially low powered amplifiers can damage
speakers when distorted sound (usually you will hear a harsh or unclear sound) is being reproduced. Speaker
damage caused by sound distortion or gross overpowering is easily evident and is not covered by the
warranty.
Trim Ring Painting
The SR62s speaker baffle and grill can be painted to match any interior-decorating scheme. Ideally paints
with nitrocellulose lacquer are used. Most cold paint types are suitable as well. Primer can be used when
darker colors are required. We do not suggest painting the inner black cavity or drivers.
SR62s Limited Warranty
Knöll Systems warrants its products sold in the USA by authorized Knöll dealers to be free from defects in materials and
workmanship. This warranty extends for one full year from the date of purchase by the consumer. Any products returned
freight prepaid to Knöll Systems and found to be defective by Knöll Systems within the warranty period will be repaired
or replaced at Knöll Systems option, at no charge. Knöll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any consequential or incidental damages. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specific legal rights. You may have additional rights, which vary from state to state. Knöll
products sold outside of the USA may be covered by warranties provided by an authorized Knöll distributor. Please
contact the distributor in the country that the Knöll product was purchased.
Specifications:
Speaker Type: 2-way
Woofer: 6-1/2" mica filled cone, rubber edge with 285g magnet
Tweeter: 1" (25mm) mylar dome
Peak Power RMS: 60 watts
Power Rating RMS: 50 watts
Amplifier Power : 5-100 watts/channel
Nominal Impedance: 8 ohms
Sensitivity: 90 dB/W/m
Knöll Systems
Frequency Range: 60Hz-21kHz tel (604) 272 4555
Mount Depth Required: 3" (76mm) fax (604) 272 5595
Speaker Diameter: 8-1/8" (207mm) Richmond BC, Canada &
Cut Out Dimensions: 7-1/4” round Point Roberts WA, USA