4.
Review the dealer-supplied installation
documents to determine which row of
screen compressions are to be used for
mounting the screen to the worksurface
brackets (C/D). The top row will yield
maximum below-desk modesty/ minimum
above desk screening. The bottom row will
yield minimum below-desk modesty/
maximum above desk screening. Refer to
Installation Appendix B for screen height and
modesty measurements.
5.
Dry fit the screen to the desktop to verify
positioning, noting the compression locations
in the screen that will require pre-drilling for
attachment to the Desk Brackets (C/D).
6.
Put the 8mm Diameter Drill Tube in the drill
chuck and use an Inner Clamp Bracket (A)
as a drill template to create the required pairs
of holes in the screen.
(Fig. 2)
Note: The Drill Tube (H) will clog with screen
material after creating 2 or 3 holes. The Drill
Tube (H) can be easily cleared by running a
standard drill bit into the tube to remove the
screen material.
The Drill Tube (H) can be reversed and both
ends can be used for cutting through the
screen material.
The Drill Tube (H) can be sharpened by using
a countersink, but one side of the Drill Tube
(H) can typically be used for 20+ holes.
7.
For all pairs of screen holes, affix an Outer
Clamp Bracket (B) to an Inner Clamp
Bracket (A) (with the screen positioned
between) using (2) 8-32 x ½” Truss Head
Machine Screws (E) per bracket set.
8.
(For L-screens only) Connect both sides of
the L-screen together with a Vertical Channel
(K) by either sliding the channel down the
sides of the screens from the top or sliding
the channel up the sides of the screens from
the bottom.
(Fig. 3)
k. Screen Installation Instructions
k. Screen Installation, continued
Fig. 2
Fig. 3
Top of
screen
Inner Clamp
Bracket (A)
8mm Diameter
Drill Tube (H)
Drill through Inner
Clamp Bracket (A)
as template
Clear out 8mm
Diameter Drill Tube
(H) with standard
drill bit
Vertical
Channel (K)
k. screen
panels
k. screen (L
configuration)
Outer Clamp
Bracket (B)
Inner Clamp
Bracket (A)
8-32 x ½” Truss
Head Machine
Screws (E)
November 2019
Part No. 3AB9099
Page 2 of 7
