IR220
IR220 Infrared Receiver Specifications:
Micro Infrared Receiver
Specifications
Installation Instructions
v1.0
Infrared carrier frequency: 30-60 kHz
Indoor reception range:
25-30 feet (7-9 meters)
Warning
: To be installed and/or used in
accordance with appropriate electrical codes
and regulations.
Nominal reception angle: 50 degrees off axis
Maximum wire length:
1000’ (300m) or more with larger
gauge wire
Wire requirements:
3 or 4 conductors, minimum
Introduction:
Thank you for your purchase of a Knoll IR220
infrared receiver. This receiver features the ability to pick up a
remote control infrared signal and relay it on wires to another
location up to 1000’ (or more).
24-gauge to 200’; 22-gauge
up to 500’; 20-gauge to 1000’
Power requirements:
Unregulated 12VDC, 40mA
Dimensions:
15/16 x 3/8 x 1/2” h
(24 x 9.5 x 13 mm h)
Cord length
75” (2 meters)
Features:
Requires 12VDC power supply, emitter(s) and may
require IR54, or IR55 connection block.
Warranty
Knoll Systems warrants its products sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights. You may have additional legal rights
that vary from state-to-state.
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way, Richmond BC V7A 4V5
Telephone: (604) 272-4555, Fax: (604) 272-5595
Made in Canada Knoll Systems All Rights Reserved
•
Will relay almost
all remote
control types
(except some
B & O and Elite
models).
•
Can be
connected with almost any 3 conductor wire
including cat 5.
•
Requires very little power. Suggest using
PS1202 12 VDC (200 mA) for up to 5 IR220’s.
•
Up to 10 or IR220’s, IR230’s and other
compatible models can be connected in a
single system.
•
Specify black, white or silver color case.
•
CFL ready design
.