DIR54
DIR54 Digital Infrared System Connection Block
Specifications:
Digital Infrared System
Connection Block Instructions
v1.1
Specifications
Infrared carrier frequency: 30-60kHz
Transmission wire maximum length: 1000’ (300m)
Emitter wire requirements: two conductor, minimum 24 gauge
to 200’, 22 gauge up to 500’
20 gauge to 1000’
Receiver wire requirements: two conductor, minimum 24 gauge
to 200’, 22 gauge up to 500’
20 gauge to 1000’
Power requirements:
Unregulated 12VDC, 200mA (up to
6 Knoll digital infrared receivers) or
500 mA (up to 12 Knoll digital
infrared
receivers).
Dimensions:
1-3/4" x 4" x 1"
(45mm x 102mm x 26mm)
Requires 12VDC power supply, emitter(s) and Knoll
digital infrared receiver(s).
Warning
: To be installed and/or used in accordance with
appropriate electrical codes and regulations.
Introduction:
Thank you for your purchase of a Knoll DIR54
digital connection block. This connection block is designed to be
used with up to twelve Knoll digital infrared receivers and is not
compatible with other infrared receivers or targets. Up to four
single and/or dual infrared emitters can be connected to the
DIR54. A 12 VDC unregulated power supply such as the Knoll
PS1202 (200 mA) or PS1205 (500 mA) is required to power the
digital infrared system.
Features:
•
Decora® style block available in white, ivory, almond
and black colors.
•
Digital processor included for connection to up to four
single and/or dual emitters.
Warranty
•
Will relay almost all remote control types (except some
Knoll Systems warrants its products sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights. You may have additional legal rights
that vary from state to state.
B & O and Pioneer Elite models).
•
Up to 12 Knoll digital infrared receivers can be connected
to the DIR54 connection block.
•
Requires very little power. Suggest using 12 vdc power
supply PS1202 (up to 6 Knoll digital infrared receivers)
or PS1205 (up to 12 Knoll digital infrared receivers).
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way Richmond BC V7A 4V4
tel (604) 272 4555, fax (604) 272 5595
Made in Canada Knoll Systems All Rights Reserved
