Customer Service:
800-550-1150,
www.knoedler.com
Fax: 450-445-0086
OPERATING INSTRUCTIONS
“
LOW-RIDER
”
Seat Cushion & Backrest Cushion Ordering Information
1. The backrest assembly includes the frame, foam, upholstery cover and the
back adjuster.
2. The seat cushion assembly, includes the seat board, foam, upholstery cover
and tilt bracket hardware.
3. To order the correct Backrest or Seat cushion assembly, select the base
number from the service parts list. Replace the (x) in the part number with a
selection from the trim code table shown below.
Example: To order a high back cushion in black Ultra-Leather upholstery
you would order a “9800-336-L21”.
GRAND-CHIEF
and
LOW-RIDER
SERIES TRIM CODE TABLE
Color
Code
Cloth
Velour
S-Leather
Leather
Black -T31
-C51
-L01
-L21
Brown
-T38
-C32
-L02
Blue
-T36
-C34
Grey
-T33
-C55
-L04
-L24
Red
-T32
-C56
-L05
-L25
Armrest Installation Instructions:
1.
Locate the armrest bracket on the backrest, this is located under the upholstery.
2.
Locate the top two threaded holes in the bracket. Top hole in the bracket is located 6.25 in above
the bottom of the back frame tube. Only two bolts are required to fasten the armrest to the back
frame.
3.
Pierce the upholstery (keep hole as smll as possible) so the armrest bolts can be installed into the
treaded holes in the back frame. Two holes must be piereced in the upolstery for each amrest.
4.
Install a bolt (M8X1.25-30mm) through the middle hole of the armrest bracket. Install the thick
flat washer on the bolts between the armrest bracket and back frame.
5.
Align the bolt with the top hole in the backrest frame. Install the bolt into the back frame and
tighten until it is engaged, (4-5 turns), do not yet tighten securely.
6.
Install the second bolt into the bottom hole of the armrest bracket. Install the thick flat washer on
the bolt between the armest bracket and the back frame.
7.
Algin the bolt (M8X1.25-30mm) with the remaining hole in the backrest frame. Install the bolt
into the back frame and tighten until the armrest bracket is drawn against the back frame.
8.
Tighten the top bolt securely.
9.
Tighten the lower bolt securely.
10.
Repeat steps 1 through 9 for armrest on the opposite side.
Summary of Contents for Air Chief Low-Rider
Page 5: ......
