MaiNTENaNCE
7
Status: 04.11.21
5 Maintenance
5.1 Readjusting the cutting edges of the cutter head
The cutting edges of the bolt cutter have a preset gap of approx. 0.4 mm.
This gap does not need to be readjusted during normal use.
If there is high level of wear, it is possible to readjust the gap.
1. Loosen the two outer nuts.
2. Push the eccentric screws up a little.
3. Adjust the gap by turning the two eccentric screws. You can choose
from 12 different positions.
Note
: The cutting edges must not be completely closed, otherwise they
can break.
1.
3.
2.
0,4 mm
Adjusting the cutting edges of the cutter head
4. Push the eccentric screws back down.
5. Tighten the nuts again.
6. Secure the nuts with a gentle tap with a
centre punch or with screw locking.
