WIRING ACCESSORIES MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following product:
SFR9905xx
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this product is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
Do not overload this accessory or subject it to conditions outside its rating
•
This product is Class I and must be earthed
•
This product is for indoor use only
•
This product is IP20 rated
INSTALLATION
•
Always ensure the wall surface is flat and smooth
•
This unit is fitted with a gasket – this must not be removed: the gasket is to stop discolouration of the
plate due to natural moisture in some wall finishes
•
This product must be fitted only after painting and decorating is complete
•
Remove the front plate by placing a medium size flat-head screwdriver in the notch at the side and lever
off gently
•
Connect to the mains supply ensuring the correct polarity is observed (see Fig. 1): L – Live (brown),
E – Earth (green/yellow), N – Neutral (blue)
Fig. 1
•
All earth connections must be made and maintained. Use green/yellow sleeving on earth conductors
that are not insulated
•
Check all electrical connections are secure with all exposed copper within the terminal and no loose
strands of cable.
•
Fit the unit into a suitable wall box taking care not to compress, damage or trap any cables, and secure
with the screws provided.
•
Clip the front plate onto the main assembly ensuring the screwdriver notch is at the side
•
Switch on and check for correct operation
BLUETOOTH CONNECTION
•
Press the power button directly under the speaker. The Bluetooth indicator will begin to flash
•
Activate Bluetooth pairing on your mobile device and scan for Bluetooth devices
•
Connect to the device named SPEAKER, SPEAKER01, SPEAKER02 etc
•
Once a connection has been established you will hear a “beep” sound and the Bluetooth indicator will
flash at a different frequency to confirm
Bluetooth audio specification:
•
Output power: max. 3W RMS
INSTALLATION
• Always ensure the wall surface is flat and smooth
• This unit is fitted with a gasket – this must not be removed: the gasket is to stop
discolouration of the plate due to natural moisture in some wall finishes
• This product must be fitted only after painting and decorating is complete
• Remove the front plate by placing a medium size flat-head screwdriver in the notch at the
side and lever off gently
• Connect to the mains supply ensuring the correct polarity is observed (see Fig. 1): L – Live
(brown), E – Earth (green/yellow), N – Neutral (blue)
Fig. 1
